Is that, is that true? A dishwasher? Was this a regular occurrence? Did they have to turn down the water heater before hand? Did they take the keys off or leave them on and how did they dry if so?
Most electronics are run through a 'dishwasher' as part of manufacturing. Hot water removes a lot of gunk that if left causes earay failure. chips are plastic, the board is fiberglass, the resisters are ceramic or plastic most capacters are ceramic, the conductors are metal - none of that cares about water once it dries. The only thing to worry about is impurities in the water since they can leave something conductable behind. Some capacters however cannon take water. Likewise I'm note sure if LCDs are sealed enough.
be careful of what soap you use though, dishwasher soap is too harsh. Manufactures are using deionized water and if any soap it is specific to electronics. Your house water isn't pure enough to do this often but once ever few years and you will normally get away with it.
Yes, electronics are often washed...in ultrapure water. Very briefly, and then immediately dried.
LCDs are definitely not sealed enough, many capacitors are electrolytic, and fiberglass is not impermeable to water (in fact, water-logged fiberglass is an issue for boats in areas where weather causes freeze-thaw cycles.)
Your dishwasher is full of mineral deposits, food waste particles, and likely quite a bit of mold. Getting rid of all of that would involve dissolving deposits with vinegar or citric acid, then running some lye or similarly aggressive treatment to get the mold and organic waste out. That's a lot of hassle.
You can't put "soap" in a dishwasher unless you want a giant bubble factory. So now you're looking at trying to find a specialty cleaner.
Most people's water is not nearly pure enough for the keyboard to not have issues afterward. You MIGHT get away with it if you thoroughly blasted it with compressed air and then dunked it in distilled water.
That's a huge amount of hassle.
Unless something has been spilled on the keyboard, just periodically brush out debris and then hit it with compressed air...
Basically: no. The construction of the Model M disallows removing the backplate after the assembly is removed from the case. On the Model F, however, the backplate is not attached with plastic rivets, and had no rubber membrane that could trap liquids, so after the electronics were removed, it is feasible to wash it in a dishwasher. Inadvisable to say the least, if you want your PCB to remain non-warped.
I've done that a few times but not "regularly". Use the top rack, no soap, no heated dry, zip-tie a plastic bag over the connector. Afterwards let it sit on the counter face-down for a couple of days to air-dry. Comes out sparkly clean.
That is true. I don't think anyone routinely did that instead of using canned air or something like that, but it was absolutely on the table for more substantial messes. Spill a can of soda into your keyboard? Run that sucker through the washer.
I have not personally done this, but google "ibm model m dishwasher" and you'll see lots of anecdotes.
You can do it today. Don’t run the heated dry and put it in with the keys facing down. Run it and take it out and leave it upside down over night on a towel. Let the connector hand down as well.
