I'm hoping for a problem that's easy to fix, but not something stupid :-)
To clarify the disk issue, we're seeing sector pulses coming from the disk drive, so the drive and cabling is working. The Alto isn't sending any read requests to the drive, so it seems most likely that the microcode isn't seeing any disk request block in memory.
A lot of things need to work correctly to get the request block into RAM. So it could be a problem with a chip on the ALU board, a bad memory chip, something wrong on the disk interface card, a corrupted bit somewhere, or anything. With the logic analyzer, we should be able to see at what point in the microcode things go wrong. The nice thing about the Alto is because it's all TTL chips, it's straightforward to see what's happening.
I noticed that 3101 SRAMs have the same pinout as the later 7400-series 7489 16x4 SRAMs; I'm not 100% sure that they are fully electrically/timing compatible, but this could end up being a way of testing using known good parts...
To clarify the disk issue, we're seeing sector pulses coming from the disk drive, so the drive and cabling is working. The Alto isn't sending any read requests to the drive, so it seems most likely that the microcode isn't seeing any disk request block in memory.
A lot of things need to work correctly to get the request block into RAM. So it could be a problem with a chip on the ALU board, a bad memory chip, something wrong on the disk interface card, a corrupted bit somewhere, or anything. With the logic analyzer, we should be able to see at what point in the microcode things go wrong. The nice thing about the Alto is because it's all TTL chips, it's straightforward to see what's happening.